Discussion Locked

Dual boot with NTFS and FAT

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have installed Win98 (using a 2GB FAT) and then WinNT (using a 3GB NTFS). I have about 5 GB left on the drive I want to format into a single partition that both OSs can read. Can this be done without purchasing software?
I seem to be running into the 8GB limit when I use NT Disk Administrator, and I am afraid that FDISK won't see the NTFS partition and will put the new FAT partition on top of my NTFS partition. Or am I misunderstanding how FDISK sees NTFS partitions? Thanks!

10 replies

by mphoffar

Fdisk will see the NTFS partition as a non-dos partition, so you shouldn't have any worries there.

You should be able to use either disk admin or fdisk, to create your partition, only problem is going to be seeing the drive fully in DOS

Goodluck to you

Mark

by simon sedgwick

Using a little proggie like FAT32 for NT, will resolve any problems you are having.
Search @ Yahoo or wherever, for "FAT32 NT"

By creating a FAT prtition NT can read it but max size is 2GB .. one FAT32 service for NT I saw says to leave you bootdrives as they are, and create your FAT32 part using 98. Once you've done that you can install FAT32 fot NT and you'll be able to acces your new 5gb partition from both O/S's ..

I've used similatr stuff myself, be sure though to read the doco with the software.

There are freeware proggies about if you're not keen on paying for it .. =)

Good Luck

by dragonnite

Mark is right about FDisk reading the NTFS partition as Non-DOS. When you FDisk you must select "Y" at the large disk option when FDisk first loads. This enables the FAT32 format. NT will format a partition in FAT but it uses FAT16 (2GB limit). You should be able to configure the extended DOS partition with the remaining HD space. WIN98 FDisk will not assign the Non-DOS (NTFS) partition with a drive letter. Reboot to enable the changes and format the new partition from WIN98.

Steve

by malibu81

cbrady,

WinNT service Pack 4 and above resolve the 2GB limit that staps an initial install of NT.

If you are dual booting understand this..
Wint NT understands FAT..NTFS
98 Does Not understand NTFS and will only reconize FAT16 / FAT32 partitions.

Therefore... Create a partition with NT or win 98 that is FAT format it as such.

As far as the 8GB limit that is an issue with The IDE interface and you may need a drive overlay program... or switch to an new IDE controller Car That is EIDE/ULTRA 33/66/100 and supports the new intrinsic call I believe it is known as INT13.

Hope this helps

FDISK will always have a problem with the reporting size if IDE is used on lage drives except for SCSI, I have Used FDisk for several 28 to 64 GB Raid Volumes with no issue but have had several problems with it using IDE Interfaces.

by cbrady

Thanks! I was really trying to figure out how to get past that 8GB limit!

This discussion is closed to new replies.