Discussion Locked

Dual NIC DHCP Router Configuration

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Should be a simple question:

Can you assist me in configuring an NT 4.0 Server with SP6a and dual NICs and DHCP enabled to act as a router between my private LAN and the internet? I have added Router 003 option to DHCP and I see that each clientshows DFG defined when queried via ipconfig /all However, the clients will not browse internet. IP address in Router 003 is defined as the private address of the server, in this case 10.10.13.21 What am I missing? Thanks for any and all help.Gary Douglas, President
NetWorking!, Inc.
eansor@yahoo.com

7 replies

by nettek

One possibility is that your multihomed server is responding to client requests back out the Internet NIC, and not back through your LAN NIC. Try adding a ROUTE statement to your server.

ROUTE -P ADD 10.0.0.0 Mask 255.0.0.0 10.10.13.21

-P makes it persistent after reboot
10.0.0.0 is the network ID (whatever yours is)
255.0.0.0 is the subnet mask for your network (whatever that is)
10.10.13.21 tells it to use the internal nic to respond to all requests from your local LAN

by shunter

Actually your solution could be quite simple. You did not mention if you had IP forwarding enabled. If not the requests on your internal card will never be forwarded to your external card and out across the web. Check that first and if it is enabledand you still have the problem I will be glad to help you further.

by systhine from tampabay.rr.com

Whoa, whoa. No!
Hehehe.
If your clients addresses are NON-ROUTABLE, that is they start with reserved addresses like 10.0.0.1, you must run a NAT (Network Address Translation) application on your server. Windows 2000 has this feature built-in underthe name "Internet Connection Sharing", but NT has no such capability. The "Ip Forwarding" option merely only enables Internet routing across your NICs and since your clients addresses are non-routable, they would not be able to connect to servers on the Internet.
So, here's where NAT comes in. It modifies individual connections to translate the client's non-routable address to a routable one (the server's external NIC address).
A nice NAT application that supports NT4 is SyGate (www.sygate.com). If you visit their site, you can find out more information on NAT.
This should allow Internet access for your clients, seeing as you have the right client configuration. They will be using the NAT server as the network gateway.

Cheers!

This discussion is closed to new replies.