Discussion Locked

DUN is connected but won't pass packets

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm having some troubles establishing a dial-up connection. Actually everything seems to hook up O.K., and I get the little icon in the corner that shows we are connected, but I get a DNS error page when I try to get on the internet, or our email program cannot find the mail server at our ISP. Sometimes I'll have to disconnect and reconnect several times before I get a connection that works. Yesterday afternoon I could not get a get a good connection at all. This morning our connection is working fine. Our ISP says there are no problems on their end and the problem is on our side. I'm running Win98SE with a 56K modem. I've dumped and reloaded DUN and the TCP/IP stack. All my DUN,TCP/IP, and DNS settings are correct. Does anyone have any suggestions as to the steps I might take to correct this when it happens again?

10 replies

by jc2

Without specifics on the modem, this is a shot in the dark, but check for drivers, check for line noise (interference from any other devices attached to that phone line) Are you using a line splitter? A thirty foot phone line extension cord? These things can make your connection erratic.
The next time you connect, but are unable to fetch a webpage, go to Start Programs MSDosPrompt and type "ping 127.0.0.1" (Leave out the quotes) This will tell you if your network stack (TCP/IP et al) is in good shape, hopefully you get four replies. If that works, try ping www.yahoo.com Find out if your network connection is dropping ALL packets, or only some of them.

by guidos

Is this PC on a network? If it is, look in Network properties at the Dial Up Adapter...look at the bindings; the only thing that should be checked is TCP/IP...if other protocols are checked, get rid of the checks and reboot. I've found that to resolve a lot of issues when dealing with dial up adapters. Hope this helps some...

by spn

OK I have had a fair amount of experience with modems,1 have you hade the line checked by the phone company.

2.Try a modem string try a generic string or specific one for your modem(also see the documentation that came with the modem)
One that normaly works well is "&fx3"
also make 100% sure that you're using the right driver,some times the "standard modem" that windows installs dose not work properly

check that , any question add a comment ,if that still doen't help, I have Other tingsu can try. Good Luck

by spn

Ok Me again, I just remembered some thing you can try,in add/remove programs>windows set up>communications add direct cable connection and hyperteminal (this is supposed to give u a more stable connection)

by guy west

My ISP finally copped to problems on their end. Thanks for all the thought and help everyone provided.

by guy west

My ISP finally copped to a problem on their end. Seems as if when it got too busy, our static IP address didn't mesh with their old hardware. Since we no longer needed a static IP address they switched it back to server assigned on their end and it's been workng fine now for 4 days. Thanx everyone who replied for trying to help me with some answers.

This discussion is closed to new replies.