Discussion Locked

Duplicate IP Address

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Recently the Novell server has reported a duplicate IP address with a specific MAC address. The problem is that the duplicate IP address is that of the server. I have physically check every device on the network and none have the IP address or the MAC address. I rebooted the server and the switches. Does anyone have any ideas?

3 replies

by deroode

There are a couple of options:

Duplexity. If the server plugs into a hub, and then the hub into a switch, there is usually no problem. This appears to only be a problem when the server is plugged into a switch.

Make sure that BOTH the Ethernet card AND the Ethernet Switch are manually configured (at least for the ONE port that the server is plugged into) so that they are set to the same speed (either 10 OR 100) and the duplexity is set to HALF.

the MOST COMMON fix is changing the duplexity of BOTH devices to HALF.

Less probable cause:

A router was bound with an address on the same subnet but with a mask of FF.FF.FF.FF, which is not valid. That router is answering ARP requests for ANY address on it's subnet.

A router had previously been configured for NAT (network address translation) and Proxy. These had supposedly been disabled but the PROXY was still active in some degree. This somehow caused the router to answer ARP requests for ANY address.

This discussion is closed to new replies.