Discussion Locked

Dvd & CD-RW incompatibility

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have built a system using an

Epox 8KTA3PRO m/b
Athlon 700 cpu
384 M/Ram
32 Mb Nvidia Riva TNT graphics
DV Action video capture card
Creative S/B Live card
40 Gb + 10 Gb HDD's
Pioneer DVD-116
Acer CD-RW 8x4x32.

My problem came about when I installed the CD-RW. Previous to this install everything worked great. After the install, while the CD-RW and the DVD were detected I couldn't get any DVD'd to play, my WinDVD software will not accept that a DVD is in the drive.

I originally had the DVD as master and the CD-RW as slave. I tried reversing them, I tried placing the jumpers on cable select, but always the same problem. When I unplug either drive, they work fine by themselves.

My questions are - Is there any known compatibility problems between the Pioneer DVD and the Acer CD-RW? Or is there a known problem within the structure of the Epox m/b and any part of the setup I have?

Any assistance will be appreciated

Regards

Steve

7 replies

by grimreality

This may sound extremely tedious but go into the device manager properties for each device and find out what the irq is, the dma settings and all memory settings. What it sounds like is you are having conflicts, unless of course you only have a limited amout of controller and are trying to run too many devices off the same ribbon.

by still_learning

Hi, Two thoughts are both devices on the same IDE channel? It is recommended that you put them on seperate channels if possible because of the bandwidth that the devices use up. Second, Are both devices trying to grab the same drive letter assignment? Good luck.

by sgod55

This worked for me! Thanks a million, I now can access both drives by placing the DVD on ide1 as a slave to the 40 Gb drive and the cdrw as a slave on ide2.

by thechas

I assume you have the Chipset drivers for the MB installed.
Go to either Epox's, or the chipset mfg website (AMD or VIA), and download the latest version of the drivers.
Check EPox for a BIOS update.
Check with ACER for a firmware update for the RW drive.

Another thing to check is updates for your OS.

I had no problem with W98 and 3 different MBs having the DVD and CD-RW drives on the same channel. My drives are not the same models as yours though.

The reason some sources suggest having the 2 drives on seperate channels has to do with CD copying. At record speeds higher than 8X, the IDE buss just cannot transfer the data fast enough from the source drive, into memory, and back to the recording drive.

by sgod55

I had done the bios/firmware updates to make sure everything was up to date. The change off the same ide channel worked. Thanks.

This discussion is closed to new replies.