Discussion Locked

DVD/CDRW combo not working

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When I boot up my laptop I get the following error message;

Devices or applications disabled
'CD recording software' will cause windows to become unstable.
Windows has prevented these drivers from loading.

Please, please, please can someone point me in the right direction of a website where I can download drivers for my CDRW/DVD combo drive. My original drivers have become corrupt and as a result Windows XP will not allow them to load. This then prevents me from reading or writing files from/to the drive.

I have the original drivers on my OE CD that came with the laptop, but because the operating system wont load the drivers I am then unable to re-install the drivers from the OE CD.

I have also networked my laptop to another PC and tried re-installing the drivers using the CD drive on the network but again no success.

The laptop is an Advent 7048 P4 2.8GHz

The CDRW/DVD combo drive is a QSI SBW242B

12 replies

by saihib

I made a mistake. This is a download for firmware upgrade. DO NOT flash your drive with this software. My inability to find driver downloads leads me to suspect that they don't exist and the Windows drivers should work just fine. That goes back to the beginning of my post that talks about the error message referring to software drivers. What burning software are you using? It may be that the software doesn't support your particular drive.

by saihib

I just looked on Roxio's website. They started support for your drive starting with EZ CD Creator 6. If you are using an older version you'll need to upgrade. Nero has supported your drive since version 5.5.8.3f.

by saihib

Copy the CD contents over the network to a folder on the laptop and then run the setup executable.

by derek

I was using Nero which worked fine until I foolishly installed Win on CD and then everything went pear shaped.

So how do I fix the problem if my cd isnt reading to allow me to reinstall Nero ?

by thechas

Starting with Windows 95, you did not need a driver for ANY CD drive.

The drivers that come with CD drives are for MS-DOS!

The IDE driver for the chip-set on your system board handles the driver duties for ALL optical drives in Windows.

For CD-RW drives, the driver for burning to a disk is part of your CD burning software package.

It sounds like you may have DOS mode or other drivers installed that should not be.

Without a better understanding of what may be installed, I cannot offer specific instructions to remove what is in the way.

You could start by running MSCONFIG and disable applications that are related to CD software you might have installed.

Most likely, it will take a few registry and system file edits to stop the offending driver from loading.

Another possibility is that you have Roxio CD Creator version 5 installed.

If you are running Easy CD Creator version 5, you need to download and install the XP upgrade.
Then, the latest version update followed by the drive update.

Chas

by hal 9000

Remove both Software Burning applications Defrag the HDD and then install only one CD Burning application.

You can not have two different Burning applications loaded at the same time as they clash with each other this is why Windows is stopping these loading as they will cause a Fatal Conflict to occur and shut the machine down.

Of course if they both do not uninstall cleanly you'll have to wipe the drive and reload all of your software.

Col

by derek

But how can i reinstall when the cd drive isnt reading???

I did try installing over the network but this was unsucessful.

by willcomp

Col, that reads like one of my answers to similar problems.

To assist you in removing Nero, here is a link to Nero utilities. There is a General Cleaning Tool and an InCD Cleaning Tool. Use both if InCD is installed, otherwise just the general one.

http://ww2.nero.com/enu/FAQs_Products_NeroBurningROM_Tools-Utilities.html#4

An uninstall may not completely remove installed drivers. The tools do a complete removal.

As Hal9000 so eloquently said, install one and only one CD/DVD burning application.

Dalton

by willcomp

Forgot:

Good info from Chas as usual.

CD drive should work in safe mode if needed to copy files. Some apps can be installed in safe mode and some can't.

by leaundrae

If you have recently upgraded to windows xp. It could be that the decoder that your previous operating system used it not regonized by windows xp. In this case you would simply need to upgrade your decoder. You could run a search on for decoder update or upgrade download the new software and you should be fine. You can also try to update the decoder that on your system know to a newer version thats compatible with windows xp.

This discussion is closed to new replies.