Discussion Locked

Eliminating partitions on a disk

0 helpful
17 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have 3 hard drives in my desktop system:
(1) a 2GB drive, which hosts the NT 4.0 operating sytem;
(2) an 8GB drive which was partitioned into 2GB primary partition and 6GB extended partition;
(3) a new 30GB drive.

I would like to utilize the 8GB drive as my system disk, with the o/s in one 8GB primary partition.

Using NT disk administrator, I have deleted the two partitions on the 8GB drive, but it still recognizes their existence and will not let me create a single 8GB partition.

I don't have FDISK in my NT system, but I have a bootable W95 diskette and tried using that FDISK to do the job. However, the result was as with NT Disk Administrator - could not do it.

Is there a tool that I can buy or download that will dowhat I want?

I considered the utilities that are offered with McAfee and with Norton anti-virus, but I don't know that they will do the job and I would prefer not to simply 'buy and try'.

Thanks,
Charles Pinsky.

17 replies

by richard_barsby

Hi yes there is Partion magic 5.0 from amazon.com. Others are also avaliable but I can't remember the names.

Best of Luck

Rich

by dmiles

1)Disk Administrator will not delete as long as it is the system or boot partition
2)A utility delpart.exe on the 3.1 resource kit,can be downloaded from the following site
ftp://ftp.microsoft.com/bussys/winnt/winnt-public/reskit/nt3/reskit.exe
Install service pack 4 to access the 8g hard drive if you have problems

by dmiles

1)Disk Administrator will not delete as long as it is the system or boot partition
2)A utility delpart.exe on the 3.1 resource kit,can be downloaded from the following site
ftp://ftp.microsoft.com/bussys/winnt/winnt-public/reskit/nt3/reskit.exe
Install service pack 4 to access the 8g hard drive if you have problems

by oskiller

This answer is a little extreme and will completely blast the partitions, but it is effective.

Make sure you have debug on your bootable disk, and connect the 8GB drive as the only drive in the system

Boot from the floppy and do the following:

a:\debug
a
mov ax,0301
mov bx,0020
mov cx,001
mov dx,0080
int13

g=100 10e

At this point the system should be completely locked up. Power off, reconnect everythingand hopefully you should be good to go.

by oskiller

Forgot to add something to the previous comment - this removes ALL partion information from the drive, so you will lose any data on the drive as well.

This discussion is closed to new replies.