Discussion Locked

eMachines problem loading devices

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have the 600is emachine with a different monitor and OS then what was installed.I have no sound and my SVGA only gets 16 colors. It came with WinME and now has Win98.

5 replies

by istmaj

sounds like the video and sound card drivers aren't installed or installed properly.

by care4earth1st

I figured that the driver and sound cards aren't installed correctly. I thought someone may know about eMachines system settings and driver installation procedures and could let me know! I was told by another technition that this is a common occurence with eMachines! I still don't know what to do...HELP!!!

by michaelrmonroe

Have you tried to explore the orignal boot disk that came with the computer to reinstall the hardware drivers? If that doesn't work then check the dip switch options/jumper settings to get into the cmos and see that the components are enabled and set correctly.

by care4earth1st

No start up disks came with this computer, since it is a used computer and I tried the setting jumpers, too...

by caquino3759

This system has onboard video and sound,open case and there should be a sticker showing what jumpers to change to disable or enable, make sure enabled!
Also W98 or W98SE tend to lose video and sound drivers on install, try www.e4me.com for drivers. This should do it!!

This discussion is closed to new replies.