Discussion Locked

Emergancy Please help me??

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When I boot my router it comes on
rommon 1>
mode again and again automatically.I do whole procedure which Cisco describe in his ICND book but router is still booted and comes on rommon 1> prompt.Here is another thing I think which should be helpfull to discover the problem when I reset it and and boot it showed the message "loadprog: bad file magic number: 0x0
boot:cannot load "flash:".
So please help me what can I do to recover my router to boot again from nvram and work properly.

3 replies

by mshavrov

It looks like you erase flash memory image. You can boot with IOS stored in ROM and then restore IOS image in flash from TFTP server. To do it you should:

in rom monitor mode:
* type "o/r 0x2101"
* type "boot" to load router

on "Router>" prompt type:
* "enable" and then enable password
* "copy tftp flash" and provide information where do you have IOS image
* "config-register 0x2102" to restore boot sequence
* "reload" to reboot router

If you have something wrong in configuration file you can avoid reading configuration by emtering register value "0x2142" on first stage and create all config from scratch or go to enable mode, copy old config to running config, remove unwanted lines and store configutration. But don't forget to restore config-register to value "0x2102".

Good luck.

This discussion is closed to new replies.