Discussion Locked

Error Codes

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When booting the server, It begins to load
the OS and I receive a General Protection
Processor Exception Error Code 00020000.
Can you tell me the possible causes!?
Thanks for the help in advance.

8 replies

by rlyon

I should mention that the server is using
Netware 3.11 which came out in 1990-91.

by muff diver

I was unable to get the page from the previous response, it had expired...This is what the Novell knowledge base has to say on that error...

Cause:
The command for the ASPICD.DSK file is being executed in the wrong place.

Solutions
1.1 The user can do one of three things. First, the user could move the load command for ASPICD.DSK file to the AUTOEXEC.NCF file, which will correct the problem.

1.2 Second, the user could upgrade the ASPICD.DSK file to one dated 05-05-93.

1.3 Finally, the user could install the CDNASPI.DSK file in place of the ASPICD.DSK file.

Also more specific to Netware 3.1
Symptom
The server was abending while viewing the lan statistics of a 3c509 card using the monitor that shipped with 3.11. Whileviewing the statistics, the screen would get a bunch of ascii characters on it and then after running for a minute the server would abend.

The abend error was a "GPPE error code 00020000. The process running was monitor main process."

--------------------------------------------------------------------------------
Solutions
Upgraded to latest version of the monitor.nlm on nsepro and replaced the 3C509.LAN driver with the latest shipping driver of 3C5X9.LAN from 3COM.

Upgrading the lan driver and monitor.nlm fixed the problem

The Novell Knowledge Base is great (www.novell.com), I would suggest checking it out if you do not find these answers specific enough to your problem.
Good Luck!
Muffy

by rlyon

Although this answer was not a complete solution to my problem, it was the most detailed and the most help. We had to find the most recent back up from the client and reloaded from a backup. Thanks for the information.

This discussion is closed to new replies.