Discussion Locked

Error Loading a Service

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

After logging on NT, the systems "hangs" for a minute and then I receive a message stating a service could not be loaded. This service has to do with my Espon Stylus 860 printer. I have used the most current drivers from the Epson website but it still continues. I would like to know how can I disable this service? I go to Control Panel|Services but it is not listed. Any suggestions? (The printer works fine. It is just annoying to have this happen during every startup)

Jeff

9 replies

by bill cassada

Before disabling the service...check to see if the printer port is setup in BIOS for ECP operation. This was the trouble for the Epson Color 740i printer I use. Alternatively I think the problem is being cause by the Epson Status Monitor. This isthe program that monitors (realtime) the ink levels, blah blah blah. You can remove this and it should solve your problem. Good Luck!

by dc1

Verify that the Epson isn't being loaded in the devices applet ad not the services

by fred_e944

Regedit (or Regedt32) and look in HLKM\System\CurrentControlSet\Services for the Key corresponding to the Service you wish to disable. Change Data for the Start Value to Reg_DWORD 0x4. This disables the service.

by jeffwatt

Items which NT lists as "Services" in the Event Log are (almost) always found in the Services or the Devices Control Panel applets. Sounds like yours might be in Devices. If so, i'd definitely recommend using that instead of editing the registry directly. Unless you really understand what's going on in there, the Registry is a quick way to hose a machine (even if you do know what's going on, an errant keystroke of mouse-click can get you in real trouble real fast)

This discussion is closed to new replies.