Discussion Locked

Error message: "Disk write error"

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Blue screen of Death
Disk write error
"Unable to write to disk in drive C:"

What does this mean and what is the solution?

15 replies

by james lowe

You may need to post more info. What OS are you using, what specificly were you doing when it died, what specificly did the blue screen of death say.

j

by steved

At this stage, all I have is a bunch of questions. Maybe one or more will help to isolate the problem.

When does this happen, during boot-up or while running applications? If during boot, at exactly what stage? Can you interrupt boot and get intothe BIOS setup? If so, is the C drive configured correctly?

Have you tried opening the system and re-seating the disk controller and the cables that connect to the drive? Have you inspected the cables for problems? I've seen a nick or a bent pin in a connector cable cause this kind of thing.

by gfrost

You indicate Blue Screen of death? Win NT or 98? Does the hard drive activity light come on? If it does then check your cable connection to be sure they are tight and correctly oriented. The pointer for pin 1 should match with pin 1 location on thehard drive and power plug should be well seated. Swapping with a known good hard drive cable appropriate for your hard drive is also a qiuck check.Failure reading drive C; means 1. no power to drive, 2. Bad cable or connection
3. a Motherboard driver for IDE is missing (unlikely) 4. Bad hard drive (possible, not so likely) Can you read drive A:? Good luck

by kima

You have to be more detailed than that.

OK, lets said you installed a new HD on your computer and your computer didn't recognize the size and you decide to load a tool such as EZ drive unto the HD so the computer recognizes the hard drive, because of this tool you could experience this type of message when trying to install and OS.

So, go back and remove EZ drive and re-format the HD make a Primary DOS partition. Also get the lates BIOS for your motherboard which might offer HD recognition of 4GB plus.

Try that, otherwise be more expecific on what you are experiencing.... I'm sort of guessing here that you are starting from scratch...

If you are installing Win00, don't worry about the rest of the hard drive, Windows has a management tool that allows you to format the rest of the HD

by craig shepherd

If it's an old hard drive like mine sometimes it stops spinning because of a build up of dust and stuff. Put you ear right next to it and see if you can hear it. Otherwise give it a few good bangs on the desk to get it spinning again.
This works for me.

by mike (from canada)

It means that your disk drive C (or hard drive) is either screwed up or it means that your drivers for the hard drive are screwed. To determine which one it is, run scandisk and make sure you perform a through test. It will check every sector and your entire drive inside and out for errors. If It contains errors then I recommend backing up the content, formatting drive C and restoring the content. you might not see it anymore. Also, your disk might be full.

by jdfcomputer

first course of action before assuming that it is a bad hard drive is check the power cable going into the drive. It is either loose, not in all the way or has a bad connector.

I suggest switching the power connction with the one for your CD player. This way you know that you are using a good connector.

This discussion is closed to new replies.