Question Locked

Error Message: Primary Slave Drive - ATAPI Incompatible

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
So I recently switched towers and now, all of a sudden, I'm getting this error message as soon as I boot my system. The error message reads "Primary Slave Drive - ATAPI Incompatible". This has really been frustrating since there's NO Primary Slave Drive even installed in my computer!! I have one hard drive installed which is recognized as the Primary Master & a DVD Drive which is recognized as the Secondary Master. My old system ran flawlessly. I'm beginning to think maybe my motherboard is bugging out cuz I fail to understand how it can be telling me that a "nonexistent" drive is incompatible. Any suggestions??

2 replies

by hal 9000

If they are IDE/ATA Drives are they mounted on the end connector of the IDE Ribbon?

If not the M'Board is Autodecting them as Slaves because that is where the IDE Lead Slave is plugged in. You should Jumper the IDE Drive correctly and then plug all Master Drives into the End Connector.

Of course if they are SATA Drives that's a different story.

Col

This discussion is closed to new replies.