9 replies
by bobo_0121
by pxyoung
Bobo - You could have "excess" collisions because you have too many users contending for a single 10BaseT shared Ethernet segment.
Collisions are normal under CSMA/CD (10BaseT Shared Segments), all users share the same logical bus and transmit atrandom intervals over it. When 2 devices transmit at the same time you get a collision.
To breakdown the Ethernet collision domain you can either segment your shared 10BaseT segment with a Layer 2 bridge or replace the 10BaseT hubs to Ethernet switches.
Switches have a logical bus per port and Each port is bridged to all others. Because each port is its own segment there is no contention; there is nothing for the transmission to "collide" with.
Ethernet Switches will also provide you with much greater performance and functionality on your LAN than 10BaseT will allow.
Regards,
Perry Young
Comdisco UK
by bobo_0121
by netwill
First, are you using a hub? If you are using a hub, check the utilization percentage. Is it constantly around 40%? If so, replac the hub with a switch or divde your hosts into 2 broadcast domains (2 hubs connected by a bridge or PC with 2 NIC).
Note: It might not be your ethernet LAN that is the bottleneck. Check your gateway to ISP. What is the CPU utilization and memory usage, queueing on it?
by bobo_0121
by kslove
by bobo_0121
by bobo_0121
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending