Discussion Locked

Event Log Warning

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Aloha!

Server: Compaq Proliant 5500
OS: NT 4 Server

Upgraded to the 64 bit dual Ultra2 Controller and the Ultra2 Duplexing drive cage. Also, we are mirroring through NT with this Duplex setup using (2) 18.x Ultra2 drives. Mirroredthe System/Boot partition
which is 2GB and also mirrored the Data partition which is most of the rest.

We are experiencing an Event Log Warning
Event #27: "FTDISK"

"The fault tolerant driver detected the system was shut down dirty".

Huh?! "Down & dirty?!" Couldn't find THAT
up on either MS Technet or Compaq Support.

Anyone know what this is?

4 replies

by village boy

This means that the system was shutdown abnormally, without the data being properly mirrored to the other partition, there are still data in the cache that wasn't flushed out to the partition.

Was your system experiencing an abnormal shutdown before the warning ?

by kahunanui

No abnormal shutdowns...in fact everything
seemed to work AOK. I do believe that it had something to do with the integrated internal controller not being terminated.
I ended up trying to break the mirrors (couldn't - gave me error that it could "not break mirror while initialising"). Probably have to re-install after terminating internal controller.

by mckaytech

The first answer is substantially correct - you will see this any time the system is powered down (or locks up) before it has reached the "okay to shut me off" screen.

Normally, it's self-correcting but you should review the prior shutdown to seeif the cause was an itchy trigger finger on the power button or a hung process during the shutdown. You may also see this when the server is set up to automatically re-boot after a BSOD - by the time you realize anything is amiss, it has already re-booted and recovered, leaving only this little event to indicate that something is amiss.

paul

by kahunanui

Everything was fine *until* we broke the mirror and tried to re-create it. See our above comments. Thanks!

This discussion is closed to new replies.