6 replies
by dmcnair Accepted solution
by moorezb Accepted solution
Just to clerify how exactly did you disable the 100MB Nic?
Might seem like a dumb question but there are a couple ways you might have to do it.
by dmcnair Accepted solution
by moorezb Accepted solution
The reason I ask is because sometimes you have to disable it in the Bios.
If that doesn't work then I would try to bridge the connections. But in your case that might not work.
For most my exchange problems that I can't figure out I go to http://www.experts-exchange.com It's a subscription site. But it is an amazing site for Exchange administrators. I'm on it everyday.
But first try disabling it in the Bios if you haven't. I'm assuming you disabled it from the Local Area Connection settings?
by richdoode Accepted solution
When you say you can ping the server, can you ping by the server name?
The problem seems to be a DNS issue. Make sure you and your clients can ping by the server name. If not check the DNS server on your network and make sure there is an entry for the Exchange server still. Make sure that in the properties for TCP/IP the correct DNS server(s) are entered and "Register this connection's addresses in DNS" is checked on the DNS tab under advanced.
If your Exchange 2003 server is a domain controller and/or a DNS server and the name doesn't resolve to an IP address do these steps on your DNS server(s) (possibly the Exchange server).
ipconfig /flushdns Enter
Net Stop DNS Enter
Net Start DNS Enter
Net Stop Netlogon Enter
Net Start Netlogon Enter
ipconfig /registerdns Enter
On the server and then on your own computer run NSLookup from an MS-DOS prompt and see if your Exchange server name is resolved OK or not. If the name and IP address resolve correctly, you're all set to try a client.
by dmcnair Accepted solution
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending