Discussion Locked

Exchange and Internet Mail Service

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just install the Internet Mail Connector on my brand new Exchange server. I have the MX and A record from my ISP. Where exactly on the Exchange server should I put those record in?. Also, in my TCP/IP properties, under DNS tab, there are two boxes, one is Host name and the other is Domain. What should I put there?
I appreciate all answers. Thanks.

10 replies

by tamj123

I think should choose forward all messages to host option under connection tab of IMS properties, and put yours isp address there.

by mckaytech

The MX and A records only need to be entered on your ISP's DNS server and not in Exchange itself.

All the entries in Exchange will be found by going into Exchange Administrator, highlighting Connections and you'll then see Internet Mail Services in the box on the right. Double-click to bring up the Properties page.

On the Connections page, in the Transfer Mode section you'll want to select Inbound and Outbound, and in the Message Delivery section, you'll probably want to select "Use DNS". On the Routing tab, you'll want to select "Re-route SMTP", enter your domain name and route it to . For the rest of the tabs, the defaults will probably work fine.

For the DNS entry, the host name should be the server name of the Exchange server and the domain will be the fully qualified domain name. So the host name might be NTSVR01 and the domain name SOMETHING.ORG.

As other questions arise, please feel free to post them.

regards!

paul

by doubledown

the MX and A records are entries for your DNS server. the records provide name resolution and tell incoming smtp mail where to go for processing (your exchange server)

in tcp/ip properties, host name is the computer name. domain name is your registered domain name (xxxx.com) or if you have an internal network, whatever you've chosen for that.

by gd

I dont think you have to mess around with any of those settings if I am right.

This discussion is closed to new replies.