Discussion Locked

FAT

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a sys running win 98 se that would not boot correctly. I ran Norton Utilities and it gave me a message that read 'Low level format is required and FAT could not be read or repaired. The Fat is physically bad.
Any help, suggestions, or info will be appreciated. Thanks

9 replies

by russ werner

When you format a drive using Windows format command you are actually addressing the scetors and tracks on the hard drive for Windows fat. A low level format actually lays down the sectors and tracks onto the magnetic media. Some BIOS systems are capable of doing a low level format, see if your's can, if not the simplest way is to get a hard disk utility program like those from Ontrack and do the low level format then fdisk and finally format. Then load your OS....

by rjluvkc

I agree. I have also seen the primary dos partition become unusable,thus not allowing the FAT to be repaired. Try deleting and creating a new primary partition. Then reformat the drive and reinstall OS.

by dmiles

Low level formatting is usually used on SCSI,when disk has some problems.
You can use the following utility to do a low level format:FMTSCSI.EXE,also download FMSCSI.TXT,go to the following site-http://www.advansys.com/support/fmtscsi.htm
also reference this site-http://ujid.tripod.com/computer/smart/s-formatdisk.html

by gregory pleau

Bad FAT is bad news. A virus could have trashed it BUT if Norton reports bad sectors or physical damage - which I suspect from this message - REPLACE THE HARD DISK. Bad sectors are rare on modern hard disks and the sudden appearance of any indicatesthe hard disk is going to fail.

Otherwise, back up your data and use FDISK and FORMAT to rebuild the drive, then reinstall Windows 98.

Good Luck

This discussion is closed to new replies.