Discussion Locked

fatal error when installing win98

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I get to the hardware set up when loading win98 and keep getting the fatal exception OD has occured at

in VXD VMM etc
I fixed memory module arrangement to get this far ...
Is this still a memory prob >?
thanks

8 replies

by dmiles

The address would have been more help to identify the specific problem,so let's go with the VMM-whish is a Virtual Memory Manager driver that needs to be loaded from Win98 cdrerun setup using your cd only or reference this site www.mcs.net/~revolutn/win98_vxd_fix.htm try locating this site before running setup again

by dmiles

Memory problems are difficult to trouble shoot,in the area that you are having problems,you will have to insure that you are using the correct memory for your system,is memory on the same bus size as the motherboard,the mother board to can be causing you a memory problem,memory could be bad,bios could not be detecting the memory,you may be using parity memory in a non-parity system.
The operating system that you are installing interacts with hardware differently than other systems,when accessing 32-bit mode drivers.Once you have system booting up,use safe mode,select step by step configuration and select (Y) at each line.Also you can reference the microsoft knowledgebase to gather more info on memory errors
articles-Q156126,Q134503,Q142546,andQ192926
Thes are a few,but the bottom line is ,if you continue to have problems then it would be best to replace the memory,first try the memory in another machine to see if the memory is the problem.Hope this helps

by jdfcomputer

2 possiblilities (configuration problems only, NOT HARDWARE)

-clean out any TSR entries in your config.sys and autoexec.bat files

-boot in safe mode (F8) and rebuilt the swap file

by jgcii

I have had this happen to me when installing win98 on a new hard drive. Although the BIOS said I had 128mb ram, I had bad memory because I replaced the memory with another and did not receive this error.

This discussion is closed to new replies.