16 replies
by mckaytech
If you're talking about drive redundancy (mirroring, software RAID), I don't believe that Win98 natively supports any fault tolerant drive features. There are some mechanisms that support automatic backup copies of the file allocation table (FAT) but nothing else that I'm aware of.
On the other hand, if you're talking about us being tolerant of Win98's faults... :-)
paul
by ripandbecca
by amieveryours
Windows98 doesn't support any fault tolerance doesn't mean you can't have fault tolerance on your Win98 desktop. There are two things you can do to have disk fault tolerance on your computer.
1. Install third party vendor raid software to manage raid for your hard disk.
2. Have a hardware raid installed to manage your hard disk.
Please note that hardware raid only supports SCSI while software raid supports both IDE and SCSI.
by ripandbecca
by rlardinois
by ripandbecca
by calves
There is no fault tolerance for Win98 OS.
A good an relatively inexpensive approach is to buy a CDRW (very often on sale for a little over $100.00) and regularly, make backup of your documents.
Just an idea!
by ripandbecca
by ec364
No fault tolerance for Windows 98. Luckily, you can use GHOST. Get a comparable size or bigger capacity drive and ghost your drive with Windows 98 to the 2nd one. Ghost takes a complete image of your drive to the other drive. Do a complete ghost, probably once a week and make an incremental backup in between. I used Ghost a lot and it really works!
Enjoy!
by ripandbecca
by bblunden
I setup a Win95 client with stripping (which isn't any kind of fault tolerance) using a program called "FastCheck." If I am not mistaken, the same kind of hardware/software can be used to create a RAID configuration. Go to their web site and checkit out:
Good luck,
Bill Blunden
by ripandbecca
by bblunden
I would do some basic hardware troubleshooting.
1. Try taking out all your cards and memory and re-seat them.
2. Try taking those cards that you can live without out and then boot (if you have extra cards, replace them). If it boots, putthem back one at a time until you find the culprit.
3. Swap out the memory (if you have a spare).
4. Swap out the power supply (I would bet this is your problem, but I have been wrong before).
5. Look at the motherboard and see who makesit and go to there web site and look for a bios update or firmware update.
Good luck,
Bill Blunden
by ripandbecca
by dlm
In a way, '98 does support fault tolerance, it just takes a little bit of work. what you can do is install a second hard drive into your system, partition it, and format it so that it is ready to accept data.
Create a batch file to run the XCOPY32 command and schedule that batch file to run at pre-determined times. xcopy32, with the right switches {/h/e/c/k} will copy ALL files, even if they are in use by the O/S.(type xcopy32/? at the dos promt for an explanation of all switches.
SO, create a batch file called 'backup.bat'
to do this, drop to a DOS promt C:\>
type edit backup.bat
inside the edit file,
type xcopy32 c:\*.* d:\*.* /h/e/c/k
exit and save the file.(be sure to see where it is being saved, I would save it in the root to be safe 'C:\backup.bat'
open win98 task scheduler, and browse for backup.bat set it up to run whenever you want. as long as your computer is on, it will run. feel free to e-mail me if you need any help!
by ripandbecca
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending