Question Locked

FIRST TIME TO POWER ON BUT NO DISPLAY

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i finish to assembled my PC but when i test to power on there is no display in monitor but still on. whats the problem here? help me pls...

7 replies

by working it

First, check and make sure it is a working monitor.

When it is power on, do you hear the hard disk running or the hard disk LED flashing?

If yes, either problem on the video card or the monitor itself.

If no, either problem on the RAM or the motherboard.

by mjd420nova

If there is no apparent power anywhere you have to suspect the power supply. If it sounds good then the video card. Some newer video cards need an extra four pin power connector on the board. The video card should be first display if monitor is turned on first by 20 to 25 seconds before the CPU. And the most overlooked problem is the insulating washers between the board and the standoffs holding the board in place. Very common oversight and usually gets caught because our suppliers glue them to the board but sometimes they do fall off. OOPpss...

by hal 9000

What is involved it's very hard to even suggest anything.

But if this is an AMD Unit you could have a Hardware Conflict between the M'Board and the Video Card this is very common and slightly less common with Intel M'Boards.

If none of the above suggestions work repost your question with a list of Hardware so it's possible to see what you are attempting to run and we'll be able to see if there are any known Hardware Conflicts.

Also do you hear any Beeps from the case speaker?

Col

by bogdan.botezatu

A common problem is the CPU misfit in the mobo socket. If it has been set otherwise than the right place and it as forced to fit, the upper-right corner pin is likely to be bent or broken. This case, the mobo gets its volts, the hdd spins, but no video, as well as no beeping sounds from the buzzer.

by d_i_n_g24

1.check the video card is hanging them Press
2.check the power supply your PC is use supply 220-volt is not 110-volt
3.Your video card is not compatible the main motherboard.

by bogdan.botezatu

Then there's a huge possibility that the CPU doesn't get its "juice" from the power supply (the secondary supply connector). Check if your source delivers its volts to the CPU.

This discussion is closed to new replies.