Hi
The floppy 3.5" disk is write protect by a hole with a sliding plastic piece.When the hole is open the disk is write protected and can be read and when it is closed the disk is write enabled. Switching from one state to the other is very simple using physical force.So to me it is hardware, but can be checked by software.Files can be made read only through software and the Read only files are like protected disks can be read but not written to.
floppy disks are measured in tracks (Cylinders) per inch (TPI) and bit density bits per inch (BPI).The total capacity of a disk is a multiplication of surfaces by tracks (Cylinders) by sectors by 512.A 3?" high density disk can hold 2 (tow sides) x 80 (tracks (Cylinders)) x 18(sectors) x 512 (bytes) = 1474560 bytes which comes to 1440K which actually cuold hold about 1380 k since the rest is used for the file system structures.A sector is 512 bytes which is astandard for both floppy and hard disk.The inner tracks (Cylinders) on a floppy are smaller than the outer tracks but floppy disks use the same number of sectors for each track (cylinder).
a sylender (track) is the number of sectors divided by the OS depinding on the type of the media.A 1.44 MB 3.5" floppy has 18 Sectors Per Track (Cylinder).
I hope this will help you.
Mohamed