9 replies
by alpha-male
Make sure it is getting a valid IP (on the same network). Check your subnet mask. Can you ping the loopback address from the machine? Can you ping the assigned IP address from it? Do you have a default gateway configured? If you release the IP address, can you get another? Try to ping the router....
For other machines to see it, do you have drives/folders shared?
Just a few ideas to get you started...hope this helps
by esbyrt
by ksearch
Remember TCP/IP is more than just TCP and IP. It's a whole suite of protocols. You say that is has an IP address, assuming TCP/IP is set up correctly (see previous users description) and all that is good, you may have problems with your Winsock and may only be using the UDP part of the TCP/IP stack. It was a common problem in Win95, but if your IP setup is good, I'd look at reinstalling winsock (can be downloaded from microsoft)
good luck and let us know how you get on
by esbyrt
by ron rs
Simplify!!! Connect only one PC and router. reboot the router. Set up the pc to "obtain IP addrress automatically". Set the pc's default gateway to the router's LAN IP address (in the Linksys manual). Set the DNS to the address specified by your ISP. Reboot your PC. Can you ping the router? If you can ping the router follow the steps in the manual to connect the Internet. If this is good, connect and configure the other pc's in the same way.
Good Luck
by esbyrt
by isys
by esbyrt
by esbyrt
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending