Discussion Locked

Getting rid of a drive letter in NT

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I had a drive partioned into C and X on Windows Terminal Server 4.0 SP5. Because I was running out of space on X, I decided to add a larger Hard drive. After adding this drive, I tried to asign a different letter to X(so that I could assign X to this drive). When I did this, an error came up stating that this drive was not available for exlusive use. However it proceeded to continue and assigned the new drive letter. When the system restarted, the Disk Administrator showed the correct drive. However, under My Computer, windows still shows the X drive, only now it thinks X and C are one and the same. Any suggestions?

2 replies

by dcraun

Sounds like you had an application running on the X drive that Windows is using. I'd recommend uninstalling everything from the X drive, then change the drive letters again.

by borisr

The only Windows process that was running was the page file. That is no longer there.

This discussion is closed to new replies.