Discussion Locked

GPF Installing Windows 95

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a machine that suddenly started giving all kinds of GPF errors. After trying numorous "fixes" I finally gave up and re-formatted the hard drive and tried to install Windows 95. It gets part way thru with the installation, and I am still getting GPF errors, even tho there is nothing on the machine. Any ideas what might be causing this? Is there anything else I can try? I thought for sure that formatting the drive would take care of it.
Thanks.

9 replies

by dft3

Since Windows scans the hard disk for errors prior to installing, I'll assume that it is not the problem.

However, what you have still sounds like a hardware issue. I would advise you to try installing with different RAM. That is usually the problem an overwhelming percentage of the time.

Good Luck! ! !

by dft3

GPF's are usually generated by the CPU, so if the RAM doesn't fix it, it could be something a little more serious like the motherboard or the CPU causing the problem. Swap out the CPU if the RAM doesn't fix the problem. Next you would have to swapout the board.

However, I seriously think your problem is the RAM.

by fred_e944

Check your memory. Make sure the contacts on the SIMMs or DIMMs are clean. Try swapping known-good memory into the machine to verify it's not the memory chips. If it isn't, start looking at BIOS and motherboard issues.

This discussion is closed to new replies.