Discussion Locked

Groupwise 5.5 printing problem

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am running Netware 4.2 on all my servers. We upgraded from Groupwise 4.1 to 5.5 in 99. The orginal GW and SP1 would print ok. When we installed SP2 and you print from GW it looks like it prints but nothing shows in the queue and nothing printson the printer. We have just installed GW SP3a and the same thing is occuring. We have to use the SP1 client on the users pc to get it to print ok. Has anyone else ran into this and if so how do I fix it.

7 replies

by bgarvey

We ran into this during our upgrade also. make sure all clients are running GW Client 5.5.3. This is working ok for us so far.

by mbrady

I would totally remove the GroupWise client, reboot, then install the latest patched client. Installation of the Print Pack 2 has caused me problems after upgrading the client. A clean install like this has solved it every time for me.

by mbrady

I don't mean to over simplify your problem, but have you checked the cable? I would do this:
1. Down the server
2. Power down the server.
3. If this is an external tape drive, triple check the cable connections. Also power down the tape drive andturn it back on.
4. If the tape drive is internal, check the cables.
5. Turn the server back on and try it.

This sounds way to obvious, but I have seen it happen before. I chased every possible software solution, and it ended being a cable that was half way plugged in.

This discussion is closed to new replies.