Discussion Locked

Hard Drive no drive letter assigned

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I installed a 40 GB Maxtor HD as a slave in a Compaq Presario 5441. It worked fine until I decided to flatten the primary Master and reload win98. Now the drive shows in device manager, but doesnt get assigned a drive letter and does not show under My Computer.
I have searched Compaq's web site for an answer, I would suspect a bios problem, but it had worked previously. Also, in the Compaq CMOS setup, I dont see any place to check or change hard drive settings.

Any ideas? (I'd trash the Compaq, but its a friend's.)

7 replies

by dmiles

Open the Control Panel,double -click on the system icon,and select device manager tab
look under Disk Drives and see if it is present,click on drive and select properties button,click on the settingstab.At the bottom of this window is a section labeled Reserve Drive Letters.By setting the Start Drive letter and the End drive letter to the same letter,you can force a drive to use a specific letter.It may have be wiped out in the mbr when you flattened your master,check the jumper set-up and make sure that you formatted the slave drive,which will cause this to happen also

by mphoffar

I would suspect that something like ez-bios to set the drive geometry was installed to get the drive to work in the last coniiguration. Now that you've reloaded it's probobly not there, and the bios is seeing it as a different geometry

There's an article on maxtor's site on how to restore the mbr and how to install ez-bios without having to reformat that may fix this for you

Good luck to you

Mark

by msillers

Compaq has disk based bios access software for most of it's computers. You may want to check the compaq web sight for a service pack which will create a bios/diagnostics disk set. Try fdisk from a DOS prompt to see if the second hard drive is visible and if there are any partitions on it. Just don't change anything until you're sure you want to. If the partition has been wiped out this would explain why windows sees it but doesn't assign a drive letter.

This discussion is closed to new replies.