Discussion Locked

hardrive

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

dear sir
i had drive c now it has changed to drive e and it is causing alot of problems
i do not know anything about computers
please tell me what to do step by step so i can understand
thanks
greybabby@aol.com

4 replies

by spn

Dear Greybabby

These thing don't just change with out reason.
What has been done recently on the computer?
New CD / DVD or Hard Drives drives installed?
Do you know what operating system you have installed ( what does it display when you restart?)

You say "it is causing alot of problems". What ? problems . Please explain what is happening
and the problems ( ie error messages in full ).

Thanks

by daz'n'ash

Right click on My Computer, click on Manage, then click on Disk Management. Next, you will now see the hard drive listed on the right side. Right click in the lagre rectangle window and then click Change Driveletters and Paths. Read the warning and procedd to change at your own risk. I have done this before and has never ben a problem.

by hal 9000

If this is a boot drive on a NT, 2K. or XP machine this will happen if the drive has its partitions removed and is reloaded to be at drive there must be at least one other Drive with 2 partitions on it.

Now because this is the boot drive it is not possible to change the configuration letter it will always be E Drive while that copy of Windows is Loaded. If you must have it reading as C Drive the only option is to remove the partitions start reloading Windows and wait until the Format option is finished then reboot and when the message comes up to "Press any Key to Boot from CD" press any key and go through the setup process again. When you are asked do you want to use the existing partition chose Yes and just continue. When Windows is reloaded the Boot Drive will show as C Drive but of course all of your software will have to be reinstalled.

If your current problems are the inability to load software you can just reinstall it and then leave the drive letters alone and the unit should work perfectly with NT. 2K or XP the boot drive doesn't have to be C drive but for any Windows 9 X to boot the C Drive Must Be the Boot Drive.

Col

This discussion is closed to new replies.