Discussion Locked

Have backup of only data on NW 5 server,

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We had a Netware 5 server drive crash and sys was on it. After checking the backup, no NDS backup was successful, only data was backed up. Is there any hope?

5 replies

by rws

If this was the only server with a replica, then you are probably sunk. If there are other servers, you'll want to refer to Novell's web site regarding removing/restoring a crashed server from NDS. They have some good TID's on the subject.

I'm not sure what backup software you were using, so this might or might not help. If this is the only server, see if the tape contains a directory called SYS:\_NETWARE. This is a hidden directory and is where NDS resides. If you can restore that directory from tape, you might be able to recreate your NDS info. Be aware that there files are in use while NDS is loaded on the server, so if you're going to try to recover them, you should probably unload DS.NLM first.

For future reference, if this is the only NW server in the tree, you can somewhat kludge a backup of NDS using a couple of Novell tools. You can access the SYS:\_NETWARE directory with TOOLBOX, so you could set up a CRON job to copy the NDS files to another directory on a daily/nightly basis befor

by fmejia

In a Multiple server Tree this is the procedure.

1. Remove dead server from Tree using NDSmanager to clean up replica rings that the dead server was part of. If the server held Master replicas promote a R/W on another server to become a Master.

2. Perform a full NDS Health check and verify that any Obits referring to the server are processed.

3. Install NW on the repaired server and add it to the Tree. Place the needed replicas on the server.

4. Restore DATA from tape.

5. Restore trustee assignments

This discussion is closed to new replies.