Question Locked

HDD failure

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Segate Baracuda 500 gb HDD that is causing issues. It began when a HP a6570a I was working on wouldn't boot past the BIOS splash screen. I troubleshooted it down to an issue with HDD (go figure)and I am now attempting to get the data off the HDD, but I am experiencing some difficulty. I have docked the HDD into an external docking station but all it does is spin up. It doesn't show up in Device Manger, Disk Management or Explorer (In XP, Vista and Windows 7). I have also tried viewing it in Linux with no luck. Any ideas?

2 replies

by oh smeg

http://www.seagate.com/ww/v/index.jsp?locale=en-US&name=SeaTools&vgnextoid=720bd20cacdec010VgnVCM100000dd04090aRCRD

And test the HDD. If it fails this test remove the drive fit just the drive to a different computer and retest. If it still fails the drive is dead and gone to [b]Silicon Heaven.[/b] If it passes the second test the M'Board, Data Lead or Power Supply in the original Computer is faulty and needs repairing as required.

Also with the Barracuda Drives you may find that there is a Firmware Update so check here for your particular drive.

http://www.seagate.com/www/en-us/support/downloads/

Now if this is a SATA Drive all that is required is to fit it to the USB Caddy and plug in with a working external Power Supply.

If it is a IDE or PATA Drive you need to set the Jumper to [b]Master[/b] not Cable Select and make sure that the Power Supply is good and actually working.

If this is a 2.5 inch Drive you need to do the same as above but as it gets it's power from the USB Cable you need to plug both of the USB Plugs into Different USB Sockets on the M'Board.

There are 2 Plugs on the Y Cable and the one at the end of the cable away from the HDD is just a Power Plug while the one closest tot he HDD End is a Data & Power Plug. The reason for this is that any drive over 80 GIG requires more than the 500 Milliamperes available at any [i]Standard[/i] USB Port. so you use the second Power Plug in a different USB Socket to get another 500 Milliamperes to power the drive.

If you only have 1 free USB Port in the computer you'll need either a External Power Supply if the case supports this or a Powered USB Hub if the case doesn't support an External Power Supply. Plug the USB Hub into the computer and then both the HDD USB Plugs into the USB Hub.

[i]Note[/i] if you are plugging this into a NB you may find that the maker of your NB has deliberately fiddled with the available power at the USB ports to extend the life on battery and you may very well need to use a Powered USB Hub if that is the case here. ;)

Col

This discussion is closed to new replies.