7 replies
by willcomp
Assume this is a hard drive that suddenly quit working and BIOS is not detecting it.
Try using different cables and connect drive to other IDE channel after ensuring that devices on that channel (usually optical drives) are detected.
If it is still not detected, you probably have an on board controller failure (drive electronics failure). The circuit board can be replaced with one from an identical, working drive or you can send it to a specialist in drive recovery. Minimum cost for recovery will be about $250.00.
One thing to try on outside chance it will work. Place drive in a zip lock bag and remove as much air as possible. Then place it in a freezer for about 2 hours. Remove and connect while cold. If drive is recognized, copy data as quickly as possible.
In short, there are no simple, quick fixes for drive electronics failures regardless of what you may have heard.
Dalton
by sgt_shultz
by dmiles
One of my favourites - put the hard drive in a plastic bag and put it in the freezer - cooling it down shrinks the parts and may enable the drive to spin up properly. I actually try this and get lots of funny looks from my wife. Still, it doesn't work.
I look at some businesses that do hard drive recovery - the prices are exhorbitant! I could buy 2 replacement drives for those prices.
See TR article 200 Wayas to revive hard drive
by wlbowers
You have electronics failure. If the bios can't detect the drive or you cannot enter the data and have the bios respond software will not do you any good.
You will get all kinds of wierd suggestions. If the data is important you will want to consider data recovery.
It is not cheap.
Check the common things first. Change the cable, change the controller it is on. Try the drive on a different computer.
Visually look at the electronics board. Do you see any black burn tracings. Or do any of the chips look like they are blistered.
If you find anything like that you could try to change the board from the exact same make and model drive.
What ever you decide I wish you Good Luck
Lee
by itcanada
sometimes just tapping on the hard drive with your finger will work as well. one quick hard tap. if the hard drive is dying you may only get one crack at it, so if it works copy important data immediatley.
also check the psotion of the clip for the master, slve or auto. may be lose.
by dcosgrove
by pf
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending