Discussion Locked

Help-Can't get secondary IP address to w

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Local police department has a message switch to communicate with a mobile network. Original server an NT 4.0 SP3 machine had two ip address on one NIC card. 10.1.1.25 and 192.168.241.82 This setup worked fine until the vendors came in and while updating the softwae blew up the system. After reloading they could not get this to work. Address translation had to be set up on the cisco 2500 router to communicate with the mobile network (198.228.31.X). Its working now but can anyone give me an idea of what they messed up.

1 reply

by kevin.dorrell

Could be anyone's guess what they might have done.

However, there is one thing that might fool you into believing that it is not working: the secondary IP address will not take effect until the machine is re-booted. It doesn't tell you this, but that is what I have found. It fooled me, anyway!

Other than that, and assuming that you have rebooted, I don't know what to suggest. What actually happens: what are the symptoms? Can you ping the secondary address from another machine on the same IP network 192.168.241.n? Are you sure you don't have a duplicate?

Best of luck,
Kevin Dorrell,
Luxembourg.

This discussion is closed to new replies.