Question Locked

HELP System Configuration Data Read Error

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a hp pavilion laptop and whenever it boots i get the message System Configuration Data updated
ERROR
System Configuration Data Read Error
F1 to Resume or F10 To goto setup

and when it attemps to start windows xp it just goes to the loading screen and freezes.

I have reset the default values in the Setup and attemped to reinstall new copy of windows but it also freezes when it starts windows.

i have no idea what to do, could it be the cmos battery?

13 replies

by tintoman

I had already made up my mind about the answer to this before I saw your last line of your post
I agree that the CMOS battery is very likely to be the cause of this

by ih8alexandwindex

I replaced the Cmos battery and it still has the same error and doesnt boot, it will run in safe mode, but when i attempt to install or run windows xp it freezes when its loading windows, anyone have any idea what it could be?

by fomianjee

It is hardware error. Take out Dimms and cpu or any other hardware which is possible. Then clean them and put them back. I had the same problem and i did that and now system is working fine :)

by x.lopez13

Update Your Bios... That worked for me. Here's what I did.
My friend has a Gateway M-1625, AMD 2GBRAM w/ Vista. I reseated the RAM, Wireless, everything that could be reseated. Cleaned off any dust. Still got Error. I eventually got XP installed. Trick is to eject disk after 1st reboot hit F1 to continue, then insert disk. Once you have XP installed update the bios.
Hope this helps. If there is no update, you might need to downgrade then update bios or reinstall. Hope this helps someone

by xraptor

your bios is probably corrupt, i would suggest taking it to a pc tech, but if you want to try to fix it yourself i'll run over the step's using ultimate boot cd (it's free and very usefull)

1st download the bios from the manufacture's website

2nd extract it to a flash drive(remember dos will not reconize folders with names over 8#'s you may have to rename it, the file you need will be a .exe file

3rd change bios settings to boot from cd(if bios is not completely corrupt)

4th boot from ultimate boot cd
select option ntfs support for dos

5th type cd b:(b is your flashdrive letter) yours could be b,c,d,e,f,g just depending on the number of drives in your computer

cd is change directory

6th change directory's to where the bios program is located and run it by typeing the file name and pressing enter.

i just hit the high points but you should be able to fill in the blanks, i hope someone will find this usefull ----xraptor----

by peconet tietokoneet

"System Configuration Data Read Error
F1 to Resume or F10 To goto setup",.
This comes up when i install Windows on a Overclocked system, i go into the Bios and put everything on "Auto". When all is loaded i then put the system in overclock mode by 10%.
Go into the Bios and select "Load system default" or something similar. and then reboot your system. You might need to recheck that your Cd-dvd drive is the first boot drive in the "Boot" options.

by 93961

It seems that you don't have your fundamentals right!!!??? :(

This discussion is closed to new replies.