Discussion Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have replaced the front screen on an IPhone 8. It was working. I shut the phone down and then I replaced the back glass. When I turned the phone back on the screen will not illuminate. I can tell the phone is working because it rings when I call it. I used a hair dryer not a heat gun to remove the glass. Any suggestions as to what could have gone wrong? Any help would be greatly appreciated.
2 replies
by oh smeg
But if the screen isn't working the Ribbon Cable that goes to the Main Board is either not attached and locked in or the Clip has broken on the Main Board.
The Front Screen has several components which have to be connected as they do different things. The one you'll see is the actual screen and the other which you will not see is the Digitizer which reads the movements over the screen so you can use your fingers to do what you want.
please don't do anything on your own. some times it can cause damage more then you think. consult specialists
This discussion is closed to new replies.
Trending Apple posts
Sort by Trending
Discussion Locked
test discussions july twenty third
0 helpful
2 replies
Discussion Locked
Apple Watch Series Review | Is It Worth It in 2025?
0 helpful
2 replies
Discussion Locked
iPhone Tip
0 helpful
0 replies
Question Locked
Apple’s Pencil
0 helpful
6 replies
Question Locked
iPhone 11 Face ID stopped working
0 helpful
5 replies