Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a NetWare 5.1 server with 3 segments. One segment attaches us to our corporate WAN, the other two segments are for our internal network. I am using BorderManager 3.5 for Internet/Firewall services. I do not want the Internet route to be broadcast over the WAN. Is there a way I can configure the NetWare server (or BorderManager server) so the Interent route is not advertised over the WAN?
3 replies
Remove or disable any routing protocol such has RIP or RIPII and use static routing.
to do this load inetcfg,select protocols, select tcpip, select RIP select LAN static routing and now for the trickly part select LAN static routing table and add your static routes.(thats the way it was in netware ver. 4.11)
Or you could add a IP filter to BorderManager that would block Routing protocols from entering the WAN segment.
I believe RIP uses udp port 520.
by turner
I tried this on Friday and it worked like a charm. Thanks for your help!
by turner
This question was closed by the author
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies