Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Using a 3com 3300 switch as I monitor it with my network mgmt software it reports a very high collision rate. What can I do to decrease the overall collisions? I was planning to add my 2nd switch and keep workstaions (Hubs) on one and servers on the other. Suggestions?
3 replies
by mtnsqs
IF the collision rate is so high then it indicates a need to split the traffic up. Another switch may help - but don't put all the servers together on one - that way you'll end up with so much traffic going between the switches (as workstations generally access the servers).
You need to split the servers up and put the heaviest users of that server on the same switch ( A managed switch will then route the traffic locally).
by lheisey
Poster rated this answer
by lheisey
This question was closed by the author
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies