Discussion Locked

HIT F1 TO CONTINUE

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
EVERY TIME I BOOT UP THE POST GOES OK, BUT THE COMPUTER SAYS HIT F1 TO CONTINUE TO BE ABLE TO BOOT XP PRO. I HAVE BEEN UNABLE TO DEBUG

13 replies

by johnm

We have two machines that have the same symptom since conversion to NT. Both have a SCSI card supporting a removable cartridge backup system. We haven't found a way to beat the hang but knowing what causes it makes it bearable. Maybe you have something like that?

by thechas

Do you have a CD in the drive?
Or a floppy?

If so, it may be a motherboard option, and not an XP issue.

One of my systems will ask for boot direction when a disk is in either drive.

To disable this, you need to go into BIOS and set the alternate boot devices to disable.

You can also get this if you originally set up the system as dual boot, and now have deleted the alternate OS.

Look at the boot.ini file for remnants of the dual boot configuration.

by mdelyea

That message will also pop up if one of your drives is not working. There will usually be a message before that like Floppy drive fail(40) or some such and then Hit F1 to continue. Check the cabling in the computer.

by gdew

It may be the cmos battery. If it is dead the system will post but give an error before booting. Error usually reports bad date or other changes made. Is there any other message given with the hit F1?

by l lynch

It's probably the motherboard, but sometimes the CMOS battery loses it's charge. Leave the computer turned on for at least 12 hours to charge the CMOS battery to eliminate that the CMOS battery has charged.
Otherwise it's the motherboard.

by gdew

I agree with lynch. Install a new battery, incase the old battery is defective and let it charge(leaving the computer on for 12 hours). If the new battery dosent fix the issue then it is the mainboard.
gdew

This discussion is closed to new replies.