Discussion Locked

Home LAN

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently just aquired cable internet and was wondering what the most inexpensive piece of hardware i would need to run 2+ computers off of it(instead of paying for two IP's). Would this just be a router, or would i need more... i've had mixed replies on this as i've already asked around.

11 replies

by frankp

A $150 four port hub would do you well. I would recommend 3COM. Another NIC would work too, although not as easy to configure as a hub.

by zilvertung

THX for the input, but cant create IP's(share one IP from ISP, then create after) through a hub.

by curacao_dejavu

You would need 2 nics (the more well known the better, but will cost you more also, but will provide you less headache in he future) and a hub.
You will need only a router if you want to hide your internal network from the internet and if you want to controll the incoming and outgoing traffic from the internet to your pc by allowing only certain ports.
BTW You can achieve this blocking also by using zonealarm.

Leopold

by zilvertung

THX for the input, but cant create IP's(share one IP from ISP, then create after) through a hub.

by ebob

The cheapest route is to put 2 NICs in one of your PCs and use it as a gateway. If you're running Windoze, then you should look into using MS' Internet Connection Sharing. You should also seriously consider something like ZoneAlarm as a firewall. This approach means that if you want to surf from the "other" PC, then you need both PCs turned on.

However, I recommend that you open up the wallet a bit further and get one of the Cable/DSL routers which are especially built for this. They all include an adequate firewall, a DHCP server (for your LAN), Address Translation (to help share the one IP address from your ISP) and typically 4 switched 10/100 Mbps LAN ports. Some have neat options like a print server and backup analogue modem, too. Look at the sites for Asante, LinkSYS, D-Link, 3Com, USR, etc.

by zilvertung

THX for the input, i dont want to use a gateway setup, both the computers arent mine, we just want to share the connection.

Looks like the cable router is the way to go(good too in case later on i end up adding more computers to the mix).

THX for making my choice concrete. :)

by computab

Because of bandwidth restrictions, you would have to pay extra for two networked PCs acessing through a cable modem. If you link 2 PCs with network cards and don't tell them, they will be upset, and might cut you off, or charge you for 2 PCs.

by paul majestic

The most hastle free way to share a cable modem would be to purchase a DSL\Cable router. There is hardly any configuring and you don't have to deal with as many settings as you do with running proxy or other internet sharing software. You can findone for just under $100 at www.provantage.com.

by philando

OK computab(answer#4), what kind of answer is that?
Zilvertung, you must have noticed a re-occuring theme ..... CABLE MODEM. It the easiet, cheapest, and most efficient way of sharing you cable internet connection. A cable modem w/4 port 10/100 switch is just a little over $100 (Linksys). Shop around on the net and you'll probably find a good price. I use a Linksys, but 3Com or Netgear will work fine. If you have more than 4 pcs, then get a 5 or 8 port hub(I would get the same brand as the router).Thats it.
The other idea with the two nic cards and configuring that pc for internet sharing is not worth the time(honestly). If you cannot afford approx. $150, then thats a good substitute. Get the router you wont regret it.
Good Luck, paison

by zilvertung

Thank you to all who answered this... all the answers were greatly appreciated.

(even #4... i'm only kidding) :)

Closed the question before responding to all the answers though(4, 5, 6), didn't see em till later.

This discussion is closed to new replies.