Discussion Locked

home network protocalls

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have just networked my house to share a broadband connection through a 4 port hub. both pc's can get on the web however we cannot share files between the two. i belive that since the internet is using tcp/ip i would need to set up netbuii in orderto share files. i need to know which format would be best to use for maximum effect. anny advised is appreciated. Thank You

10 replies

by fgarber

You can use tcp/ip for sharing files. You must install the file and printer sharing service and make sure that the pc's belong to the same sub-net and the same workgroup. Then you can set the web machine as the default gateway. That should get everything talking. If you need more info just send me an email.

by rcc

First, is not GOOD to run MS File and Print Sharing on an Internet connected network interface, unless you have an IP filter that keeps outsiders snooping or connecting to the ports used by this protocol.
Second: You can do it with TCP/IP. Make sure that:
- you have the appropriate permission set to allow file sharing
- computers can ping each-other and are on the same subnet (as previously said)
- you have an lmhosts (NO EXTENSION!) file on %WINDIR% (C:\WINDOWS) and the file on each computer contains the entry:
IP ADDRESS THEOTHERCOMPUTERNETBIOSNAME #pre and you have the NETWORK settings changed to use LMHOSTS name resolution
If you do not want to do this, you can simply install NetBEUI, which is a non-routable protocol andwill allow to share information between the two computers without any headaches.
I hope this helps.
Regards,
Radu

by kevin anderson

Windows 95 SR2 and better (98, 98se, ME, NT, 2K) all use TCP/IP for communucating.

Generally, this is due to NT trying to talk to 9x and not having an account on the NT box for the 9x user. Can you please advise which OSes you use? Can you pingfrom one to the other?

You need to enable file sharing before this will work. MAKE SURE YOU USE PASSWORDS. Sharing files like this means they are shared over the whole internet (I could map a drive to them), so at LEAST have a password in placefor any shared printers/folders.

Kev.

by nuttinbtspeed

I am using Windows ME on both systems. I do have a firewall protected router\hub. the two systems do not ping each other by using the ping command 111.222.333.444(not the real #) it says it timed out. they can ping outside address fine with an averave of 28ms responce time.

by dlafrombois

With out revealing to much information, more information is needed. From your comments, I can only make the conclusion that each station is not on the same segment (the two systems do not ping each other by using the ping command 111.222.333.444(not the real #) it says it timed out).

This is a issue you need to resolve first before you can go further with sharing.

Second, enable NETBIOS over your TCP/IP. If you can ping each station then sharing can be accomplshed with any of the above solutions. I have a similiar setup, so I know it works.

Good Luck with the troubleshooting.

This discussion is closed to new replies.