Discussion Locked

Home Office Network and Internet Access

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm trying to set up an office at home which will have a few machines running assorted O/S's (Windows 2000 Server, Windows 2000 Professional, Windows ME and Linux). I would like all these machines to be able to access the web via an ISDN router. Does anybody have any good advice on where I could find information on setting this network up, any problems I may not have foreseen or any tips on how to get started?

2 replies

by pete

Fairly clean installation. A couple of pointers:
1) Don't do NetBEUI ! It is a very 'chatty' protocol. I assume your ISDN is a measured rate. Use the router to turn off the connection every, say, 3 minutes. NetBEUI will bring the connection up and cost you more time than you would immagine.

2) Cisco has a great site for knowledge depth in communication technologies. Netopia makes some solid router/network gear that has a friendly interface. I don't see any Macs in your network - if you did Netopia is very Mac friendly.

3) Think about a router that has 2 POTS channels and is capable of distinctive ring and other programable options. If you ever go to broadband, ISDN options provide inexpensive phone lines compared to two straight analog. The router can double as a voice/fax terminal device.

4) Loose the serial connection to your router and use telnet. Provides the flexability to manage the router from anywhere on the network.

5) Bottom line: don't neccessarily get the cheapest ISDN router. Think ahead about how you would might/might not use it after ISDN.

by shropshire lad

Although I haven't subscribed to the ISDN service yet or purchased the router I'll take all these points on board. Thanks for the help!

This discussion is closed to new replies.