Discussion Locked

How 100BaseT hub's Uplink port work?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Many of us know that we can use a UTP cable between the wall's RJ45 outlet and a 100BaseT hub's Uplink port so that we can string off more workstations.

I'd like to know what really happens, from a "logical" topology point of view.

1. Does this create a new "second" logical bus segment that strings off of the first?

Or...

2. Does this "lengthen" the original bus through that UPT cable to maintain a "single" logical bus throughout?

3. I could be wrong on both explanations. Can you help?

Thought I'd ask here first before I start calling up the hub manufacturers.

Many thanks and kind regards

Kyu
www.infouser.com

7 replies

by bart777

If you are simply using the RJ45 plug to link to another hub, then all you have done is lengthen the collision Domain. It will all be part of the same logical topology.

If the oject is to segment the topology and seperate the 2 locations, you might consider a Bridge or router at either end.

Hope this helps,

Best of Luck

by mckaytech

It could depend on what is on the other end of the "wall". If it is a switched port, the net effect of the hub is to extend the collision domain from one workstation to several. In that sense, I guess I would agree with your statement #1. If what is on the other end of the wall is another hub, I would tend to agree with #2.

However, your question is intriguing because the concept of a "bus" is not usually used in network topology and I find myself wondering whether there is another underlying question that we're not answering.

paul

by maxwell edison

Unshielded twisted pair (UTP) cable does not rely on physical shielding to block interference, but on balancing and filtering techniques through media filters and/or baluns. Noise is induced equally on two conductors, which cancels out at the receiver. With properly designed and manufactured UTP cable, this technique is easier to maintain than the shielding continuity and grounding of an STP cable.

UTP cable has evolved over the years, and different varieties are available for different needs. Basic telephone cable, also known as direct-inside wire (or DIW), is still available. Improvements over the years, such as variations in the twists or in individual wire sheaths or overall cable jackets, have led to the development of EIA/TIA-568 standard-compliant Category 3 (for specifications on signal bandwidth up to 16 MHz), Category 4 (for specifications on signal bandwidth up to 20 MHz), and Category 5 (for specifications on signal bandwidth up to 100 MHz and greater) UTP cable. Because UTP cable is lightweight, thin, and flexible, as well as versatile, reliable, and inexpensive, millions of nodes have been and continue to be wired with UTP cable, even for high-data-rate applications. For the best performance, UTP cable should be used as part of a well engineered structured cabling system.

This discussion is closed to new replies.