3 replies
by mlehr Accepted solution
by robo_dev Accepted solution
If you just need CLI access, then configure enable SSH and create a NAT rule for that and you're done.
Depending on where you connect from, you might want to create an ACL for a particular IP address or use a non-standard SSH port for additional security.
see the guide below for the config:
http://www.cisco.com/en/US/tech/tk583/tk617/technologies_tech_note09186a00800949e2.shtml
NOTE:
Looking at your current config, above, you've posted your router username and the hash of both your device and enable passwords on the Internet :) (so you might want to change those). You also posted your dyndns username AND your domain name, so an attacker knows what door to knock on. I can also see the NAT rules which show what ports are open AND the internal IP address of each server. I am not trying to be snarky here, but really that's making an attacker's job a lot easier.
by mlehr Accepted solution
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending