Question Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hi everyone, I need help setting up my Panasonic kx-tda100. I am required to connect 85 phone extension lines. We have also procured 4 pieces of KX-TDA1178X (MCSLC24) extension cards which I think are appropriate. We also procured DTA 204X Amphenal cable that connects from the extension card (MCSLC24). I am confused about how to connect the phone extensions to the PABX. Can someone please guide me on how to connect the PABX to the telephone extensions and what hardware I need to install in between the PABX and the phone extensions. This is for the hotel where I'm the IT Engineer. I look forward to your suggestions.
2 replies
by aw_willis Accepted solution
Clarifications
by robo_dev Accepted solution
Do you mean the premise wiring where the 66-blocks have the extensions punched-down? Typically you have a 66-block with either RJ-11 jacks on the side (pre-wired modular jack blocks) or some come with the big jack for the standard Amphenol connector on the side which can terminate 25 pairs into one tidy cable. You can also buy a cable that breaks out the Amphenol cable into 12 individual male RJ-45 cables
http://www.siemon.com/e-catalog/ECAT_GI_page.aspx?GI_ID=66_pre-wired-m4-series
http://www.siemon.com/e-catalog/ECAT_GI_page.aspx?GI_ID=66_pre-wired-m4-series
This discussion is closed to new replies.
Trending IT Employment posts
Sort by Trending
0 helpful
2 replies
0 helpful
11 replies
0 helpful
1 reply
0 helpful
6 replies
Discussion Locked
How should organizations verify AI generated information before using it
0 helpful
0 replies