Question Locked

How do I enable on-board graphics when monitor gets no signal?

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I was having problems with a Nvidia 570 GTX getting micro-stuttering, so I uninstalled the driver so I could try an older driver.

I enabled my on-board graphics before restarting. I use Windows 7.

Now my monitor isn't able to get a signal from any port. I can't do anything in the Bios because my monitor just says "No Signal". I tried unplugging and replugging in my computer.

I have no idea what to do at this point.

6 replies

by seanferd

You don't have the cable plugged in correctly, or the graphics chip has taken this moment to die entirely.

"I enabled my on-board graphics before restarting"

So there is onboard and a separate graphics card? Otherwise, why would you need to enable onboard graphics, right? If so, make sure the monitor is plugged into the right graphics port.

by robo_dev

If you set a fatal setting in BIOS, you typically can clear that with a jumper on the MOBO or pull the CMOS battery for a little while.

It's also common that the MOBO video is analog and the video card is digital. Two different connectors, obviously, but some monitors have to be manually switched between analog and digital inputs, or sometimes just power-cycled to do that.

by oh smeg

Removing the Plug In Video Card. Typically if these are not correctly inserted in their socket or in the case of AGP Cards the computer gets moved around the Video Card can work it's way out slightly and you get no Video Display.

So the answer here is to re-seat the Video Card or remove it to start sorting the problem.

I would also look inside the Video Plug for Bent Pins which can also happen occasionally.

But as said above if you have made a Fatal Error in BIOS all you need do is change the Jumper to Clear or remove the Battery. If you remove the Battery remember to first unplug the Power Lead and allow the LED's to go out so you don't do any damage if you drop the battery. Metal Cases Batteries cause Short Circuits and damage to M'Boards with Power.

To reset the BIOS all you need do is enter it set the current Date & Time and then Load Defaults. Save the changes as you exit the BIOS and you're off and good to go.

With most M'Boards when you plug in a Video Card the On Board Video gets turned off.

Col

by steveno.four

had to ask...also check and see if the monitor is bad by swapping with a different one.
sometimes they do funny things. i even had a bad power supply cause a similar issue.

by mr_phatal

First I would check if the mobo has an onboard video card, then I would just simply remove the old video card and attach your video cable to the onboard. By default the onboard will work without any bios settings.

This discussion is closed to new replies.