Question Locked

How do I move a Raid0 to a similar machine?

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I obviously messed up my BIOS or motherboard of a Precision 390 while trying to upgrade to another processor. Bios hangs up on save/exit.
Vista often reboots on start up, not always.
I want to save the Raid0.

Since I have a similar Precision 390, I am planning to move the Raid0 array to that one - I have seen once that replacing a motherboard with a Raid0 is possible without deleting the array.

Question is, how to do that. My 390 manual refers to setting up a Raid array always with the remark "warning: this will erase all data" -- which I really want to avoid.

Thanks!

4 replies

by robo_dev

if the new MOBO is exactly the same drive controller chipset, it should work, or else it will BSOD when Windows starts.

I would make a clone of that disk with something like CloneZilla with the old MOBO?

Not sure if a Raid0 drive could be cloned in an external drive case.

by churdoo

If so, the RAID controller (assuming same RAID controller) on the other mobo should read the RIS data off of the disks when it starts up the first time and the RAID controller should recognize the RAID. It might ask you to confirm during POST.

With hardware RAID, not only is the RAID info stored in the controller's non-volatile RAM, but is also written to each member disk in an area of the first cylinder called the RIS (RAID Information Sector I think).

By moving all of the member disks to the other mobo, the RAID controller will read this config from the disks and should recognize the existing RAID0 just fine.

If any concerns though, you may contact the Mfr tech support as they typically have back-door keystrokes where you can re-create/re-define things without wiping the data.

edited: typo

by charles bundy

I've used both tools on DELL servers running RAID5 arrays off PERC 3/DC controllers.

Assuming exact hardware just create your RAID0 on the new box and do the following.

I. have an FTP server handy and create an "install" user. Put them on the BIG partition.

II. Boot G4U on the old box and use the disk command to save the entire physical drive to said FTP server.

III. Boot G4U on the new box and use the slurp disk command to write the image to your RAID0 array you created using BIOS.

IV. Run GPartEd and resize the partition if the old array was smaller than the new.

WARNING DANGER WILL ROBINSON! Remember the new array has to be same or greater in size to the old array!

Also as you were running RAID0 which isn't really redundant coupled with Vista, it's my humble opinion you will be imaging bad bits. Can't help you there, but steps listed above will move the data (corrupt or no) over to the new machine and let you boot, utilizing free open source tools.

This discussion is closed to new replies.