Discussion Locked

How do I support multiple Video Monitors in a Command Center?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an IP Camera Video Surveillance System with approximately 45 IP cameras. There is a Network Server that will drive the management portion of the video surveillance system, but there is no Network Video Recorder as recording video is not required. I would like to support up to ten 20" video monitors in 2 locations for live camera viewing only. With IP cameras, I am assuming I will need monitors with a VGA input as the video signal will be computer generated. I don't want to have multiple PC's supporting only 1 or 2 monitors each. So how can I accomplish this large amount of screens efficiently?

3 replies

by $dunk$

I've never had to do anything like what you're asking but my guess is that you should be looking into a chassis of single board computers. If you get graphics cards that support 2 monitors each, then you'd need a chassis that can support at least 5 Single Board Computers.

by bryan

Buy a ATX tower computer and a ATI FireMV 2400 card. It
runs about $400 (from cdw) and operates 4 monitors per
card. I have 3 cards installed on my computer and operate 12
monitors on it. It works great!

by jdawson

I had been investigating this option, but I am concerned that I would be putting all my eggs in one basket. I think I will split them up to maintain some level of redunadancy and servicability. Thanks for the input.

This discussion is closed to new replies.