Question Locked

How do they stretch a cable that far with no performance hit?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

This is in re: to "Australia's 5,500-mile Internet connection"
http://content.techrepublic.com.com/2346-10878_11-196690-1.html

I know this will be a very newbie like question, but I've always wondered how they extend these cables so far? For example, Ethernet cables (cat5) have a max distance of approx. 300 ft before there is performance degradation. I understand Australia is not stretching a cat5 to Hawaii, but how is there no performance degradation with what their using? Do they use some kind of (switch-like) link every X miles?? Enlighten me. Thanks!

7 replies

by older mycroft

[i]"The cable is dropped straight to the sea floor without any weights or extra protection. The only additional baggage is the optical signal amplifiers, of which 121 were used in the connection from Sydney to Hawaii - one every 75km.

The inner most layer is the fibreoptic cable, which is surrounded by a steel sheath. This is, in turn, coated in a copper sheet, which carries 12kV of charge to power the optical amplifiers.

The final layer is the white plastic insulation that protects the cable. Telstra claims the cables have a 25-year lifespan."[/i]

http://networks.silicon.com/broadband/0,39024661,39187855-3,00.htm?r=1

In both the TechRepublic & the Silicon.com articles, the repeaters are under photo #3.

So - who plagiarised who then ??
:)

by jdclyde

is what your working with when you use fiber optics.

the cause of the 300 ft limit is TIME for the signal to travel over the copper.

Light travels much faster than electrical pulses, so it can hop much further between repeaters.

Smarter switches/routers at each end also help.

by dr dij

due to the soliton wave which holds the waveform until amplified.

the error rate is very low due to this.

when they try and cram vast amounts at multiple frequencies onto a single fibre the waveforms of the dift frequencies will travel at a slightly dift rate.

by dr dij

as others mentioned, goes much further as it its light not electricity as in cat5 cable.

the cores reflect light back into the center. The speed of the signal is also faster in fiber optic than in metal (cat5).

And because the whole link is closer to speed C than signals in metal media (C = speed of light in a vacuum) there is much less overall delay than bouncing the signal off a geo-synch satellite (where you could get 1/4 second, 1/2 second roudn trip) because you are not sending the signals 33,000 miles into space.

The protocol is also NOT ethernet which would not work or be efficient for such long distances.

Finally, instead of converting to electricity then re-injecting the signal every 75kms these long hauls typically use a short segment in-line of erbium-doped light fiber. Photons hit the erbium doping, which is pumped up to an excited state with an external laser. The atoms then re-emit the signal amplified.

The wave is typically a soliton wave which will not degrade in waveform unless it falls below the threshold entegy. To see more about this, read the sci-am article about 10 years ago. This was so unique an idea they even did a star trek NG episode with soliton waves propagating in free space.

This discussion is closed to new replies.