7 replies
by skippyhiatt6481 Accepted solution
by alphatech9 Accepted solution
I don't know what you are trying to build..... but all you really need is a copy of Cisco CCNA Network simulator .....
If you want actual hardware to play with plugs and wires you need a Cisco router ....CCNA has nothing to do with PCs for the most part. You need to know PC basics, and network protocols but what you REALLY need to do is get into the CLI of some Cisco hardware.....
I passed my CCNA having only worked on an actual Cicso router three times.... all my lab work was done on the CCNA simuator. You can build any size virtual network you want on there.....
by cg it Accepted solution
actual hardware for CCNA/CCNP you need 1 router and 1 switch to learn the CLI.
after that just simulators. besides here's the formula for calculating # of watts on a circuit
Circuits must be derated by 20% A SAFETY CODE REQUIREMENT. Maximum wattage allowed on a circuit is calculated by multiplying the derated amps by the voltage.
Example:
20 amp circuit with 120 volt application
1. 20 amps x 20% = 4 amps
2. 20 amps - 4 amps = 16 amps (max allowed)
3. 16 amps x 120 volts = 1,920 watts (max allowed).
A 20 amp double pole circuit breaker,
? 3,840 watts is max load allowed on a circuit
if you put 3 of your towers on 1 circuit, 3 on another you should be fine [that's assuming you have all 6 running 24/7/365]. The real question is why pay for that if your not using all 6 all the time.
the cisco equipment power supplies are very small compared to a computer. The cooling fan draws more amps than the processor board does.
but if your looking to get even with a neighbor, think again. the circuit breaker would trip if the draw against it exceeds its rating. 15amp and 20amp breakers would trip if there was to much draw on the circuit.
by skippyhiatt6481 Accepted solution
by skippyhiatt6481 Accepted solution
by imus_rl23 Accepted solution
by exnn Accepted solution
This discussion is closed to new replies.
Trending IT Employment posts
Sort by Trending