Question Locked

How the heck do I re-assign an LPT port?

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
The company i work for uses vinyl cutter/plotters, unfortunately, the software only allows the cutter to use LPT1 unfortunately, this PC has had its parallel ports installed, and have been numbered 2 and 3, with no other parallel ports installed.

4 replies

by tardcart

Device Manager and get into the properties of the LTP port. On the Port Settings tab change it back to LTP1 in the LTP Port Number drop down.

by oh smeg

And disable any LPT Ports on the M'Board. This sounds like a Add in LPT Card has been fitted here but it is possible that the M'Board has a Header on it that you plug in a Fly Lead with a LPT Connector and mounting bracket to fix tot he Back Panel. If that is the case here they will need to either fit the Optional Lead or disable that function of the M'Board.

Also depending on the type of Printer Card Added here there may be some Hardware jumpers that need altering so they would have to look in the Device Manager and Identify the Printer Card before proceeding any further. It may not be possible to use the Software Option to change these settings.

Though Device Manager would be my first option if I couldn't open the case easily. ;)

Col

by tom

It wasn't worth buggering about fixing, just changed machines, the software wasn't having a bar of either option unfortunately.

This discussion is closed to new replies.