Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a broadband connection with a static ip i have con figured tht in a cisco 1841 series router and everything is working fine .now i want to restrict the internet to limited user from my internal network.I also want to enable http for a particular website only
3 replies
by sobhan1974 Accepted solution
Clarifications
by peconet tietokoneet Accepted solution
by defrey74 Accepted solution
You need to create an ACL (Access list)on the router interface to deny/allow traffic incoming or outgoing
Note that you can configure 2 types of ACL, but i recommend Extended ACL
eg:
-> Configure your ACL
R1(config)# access-list 101 permit tcp "network address" "wild card mask" any eq 80 (any eq mean port number)
you then need to apply the list to the interface:
#interface fastEthernet 0/1#
#ip access-group 101 out (outbound)
#ip access-group 104 in (inbound)
Good luck
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies